Randy S Houston , TX June 24, 2017 Appliance: Maytag 30" Built-In Microwave/Electric Oven Combo Self-Clean JMW9330DAB16 The control panel was no longer working lights were not coming on no beeps could be heard hen you hit a key on the control panel it first started with the 3 6 and 9 keys and became worse I replaced the old control panel with a new one. I also changed out the door seal to help prevent the control panel from going bad a second time. It was the heat from the oven getting to the keypad on the control panel that caused it to go bad. Read More... 4 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours Tools: Screwdrivers, Socket Set
Jeffrey W Hudson , WI December 14, 2019 Appliance: Maytag 30" Built-In Electric Oven Self-Clean Convection JJW9330DDS13 Buttons on stove quit working. We have this model in stainless steel but couldn't find a stainless control panel anywhere so we just settled for the black one to hopefully get a few more years of life. The job was easy and straight forward. All that you need is a phillips and hex-nut screwdriver. Once you get the oven slid out a bit there are just four hex nuts that hold the panel to the frame. Pop those out and the panel comes off after which you disconnect the two ribbons and unscrew the board from the panel. Replace the old with the new, reassemble and wah-la I had a working stove again. I also chose to replace the 10 year old door seal as it was a little crusty and leaking heat. That couldn't have been easier either as the tabs on the seal line up with the holes in the door. Easy press fit. Probably 20 minutes from start to finish. Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers, Screwdrivers
Blanchatd C Boerne , TX April 09, 2016 Some of the buttons on the control panel did not work Replaced Control Panel Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers, Screwdrivers
Terry N Pearland , TX November 09, 2015 Certain buttons on the control panel stopped working It was fairly simple to replace. I removed four screws anchoring the oven to the cabinet and pulled it out a few inches. I removed two screws with a nut driver from each side of the oven to remove the control panel + control board and mounting bracket. I moved the control board and mounting bracket from the old control panel to the new one (eight screws) and put everything back together. All buttons work now! Read More... Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Nut Drivers, Screwdrivers
Robert S Ozark , IL May 08, 2020 Could not dial in temperature in oven Replaced front panel of stove. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers