Lee P Los Altos , CA October 18, 2014 Appliance: Model KENMORE 110.47512600 F 28 error code on kenmore he 2+ washer Pulled Motor Control board as the most likely problem as described in numerous complaints on the internet. The board had several burned resisters. The replacement board fixed the problem. Read More... 7 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Nut Drivers, Pliers
Rocio P El Paso , TX November 30, 2014 Appliance: Model KENMORE 110.47512602 Failure to finish last cycle door would not unlock and machine would not agitate In the initial failure the machine would not finish its's cycle to the end. The door would not unlock. Tried the troubleshooting guide in the manual and went through the series of troubleshoot instructions. Checked motor field continuity, door latch and checked drain filter and drain motor. Did not get an error code until I unplugged machine and watched the F-28 code on panel. I then got the machine to run and found the machine would not agitate. This is when I knew it was the motor control unit (MCU). Ordered it and installed the new MCU. Machine went through a full cycle after plugging machine in. I then ran it through a full wash and the machine is operating like new. Part is expensive! Read More... 4 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours Tools: Nut Drivers, Pliers, Screwdrivers
Allen H Berkeley , CA October 02, 2015 Appliance: Model KENMORE HE2+ Code f28 appeared on kenmore he2+ New Motor control unit did the trick. Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Adjustable Wrench, Nut Drivers, Pliers, Screwdrivers
Iris V Orlando , FL October 17, 2014 Appliance: Frigidaire Frg(V2) / Chest Freezer H20B The washer did not start the wash cycle Called Appliance Parts Pros needed a new electronic control board .The customer service agent Heather walked me thru the process and it was easy.The repair went well changed out the old board and the washer was up and running thank you Heather wonderful job. Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers, Screwdrivers
Brent V Crestview , FL February 06, 2016 F 28 error code mcu was bad I gave a whirlpool duet sport ht and the drum would not spin except for about the first 20 seconds of the cycle. I did some research and found out how to trouble shot the MCU and CCU. The MCU tested bad so I ordered the part I needed it shipped to me in two days. I installed it that night and the washer was up and running that night. Read More... Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Nut Drivers, Screwdrivers