Whirlpool W10365146 Cooktop Glass Top Surface Panel OEM Part

I turned off the breaker to the Cook top, I then got under the counter and pushed the cook top through the opening in the counter, placed the cook top over the opening on the counter to stabilize it and then I used a Phillip head screwdriver removed all the screws , lifted the broken glass and put on the new glass, replaced the screws, placed the cook top back into the opening on the counter and turned back on the breaker. I need the foam tape that goes around the edge of the glass and didn't realize it didn't come with the glass top.

Replaced glass top.

Turn power off. Always verify power is off by using a voltage meter or seeing if burners don't come on. Underneath cook top remove all screw that is holding cook top to counter. Lift cook top out. (If cook top does not lift out, I used a utility knife underneath side and front edges of cook top, avoid scratching counter top). Unscrew screws holding cook top to base, lift top off, replace with new top. Screw new cook top to base. Check seal around cook top and counter top, mine had a thin rubber gasket. Place cook top back. Use a tape measure to align cook top straight with counter top. Tie down cook top to counter top, do not over tighten. If you had to disconnect power, reconnect power, turn power back on.

It was super easy, i remover about 10 screws, removed the old top, installed the new top, and reinstalled the screws.