Samuel S Harrisburg , PA March 15, 2016 Appliance: Model WHIRPOOLWASHER 1999 MODEL Broken bleach dispenser cup Replaced with new part. 5 minutes. Read More... 3 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes
Norman W Bismarck , ND May 18, 2020 Appliance: Kenmore Washer 11023832100 Worn out contact in the timer not allowing it to spin/ The washer would work fine except it wouldn't spin unless you opened the lid and waited a split second for it to stop. You would hear a bang, then when you closed the lid, it would spin. Since it made that bang noise, I thought the transmission was going bad, so I replaced that. Nope, still the same. So, after a little more research, I found out that the motor has to come to a complete stop for the transmission to go into spin mode. After pulling out the timer and inspecting it, I noticed that one of the contacts wasn't opening hardly at all and it was burnt looking. It wasn't allowing the motor enough time to stop, so it wouldn't shift into spin mode. Replaced the timer and it works like new again. Plus, since I put in a new transmission, it's quieter too! Replacing the timer is about as simple as it gets. Watch the video and you will see what I mean. All you need is a 1/4" nut driver and a Phillips screwdriver. Took less than 5 minutes. Read More... 3 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers, Screwdrivers
Curtis C Modesto , CA July 11, 2014 Appliance: Whirlpool Washer LSQ8000HQ0 Broken tab to hold bleach dispenser cup in place Replaced bleach dispencer cup Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes
David M Virginia Beach , VA March 31, 2015 Washer agitator broken Replaced agitator Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Socket Set
John W Fallston , MD November 29, 2014 Appliance: Whirlpool LA8800XTW0 Cold water was leaking into the tub when washer was turned off Ordered the new water inlet valve to correct the problem. Before I had a chance to replace the part, the leaking stopped. Holding on to the valve in case it resumes. As for Appliance Parts Pros, they were very helpful in identifying the part needed and I received the part very quickly. Great service! Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes