Whirlpool 8185239 Door Assembly (Black) OEM Part

Ordered the new door assembly and installed it. Had to remove the bottome cover (8 screws) and 1 screw on the top cover to access the hinge screws. Removed hinge screws and replace door. Took 5 minutes.

I had to remove the top vent to get to the upper door bracket. I also had to remove the lower panel protection to get to the lower door bracket. Once I removed those pieces, replacing the old door was a piece of cake. There's three screws on each bracket. I had to use a socket wrench to get them off. There are about 8-10 screws on the lower panel. For that I used a Phillips screwdriver. If I can do a repair like this anyone can. I usually don't have the patience to repair anything...lol.

Removed the 4 screws above the trim / vent. Removed the front and side screws from the underside of the oven hood and lowered on the rear hinge. There are three bolts on the upper and lower hinges of the microwave door that remove easily. Caution there are washers on each of the hinges... Do not lose these. Installation is the reverse. Did the replacement without any additional help.

Ordered new door and grill replacement. Had to pry the plastic cover off the new door to get access to the metal hinges that I didn't need. Took the new hinges out. Popped the new door onto the old hinges left on the microwave. Then pushed the cover over the door and replaced the 3 screws and looked good as new. Might have taken 15 min maybe.