William B Rocky Mount , NC December 17, 2018 Loud squealing noise First replaced the drum rollers...that wasn't it..took dryer back apart and spun the belt tension wheel by hand (should have done this the first time I took the dryer apart) and it squeaked. so I ordered the full parts: wheel, idler arm, idler spring, arm sleeve, E ring..Put it back together and whoa..no more squealing!! Read More... 12 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Nut Drivers, Screwdrivers
Richard G El Paso , TX December 18, 2018 Appliance: Model MAYTAG NEPTUNE The rollers needed to be replaced, the axles for the rollers needed to be replaced, the tension pulley roller needed to be replaced, the belt needed to be replaced It took me about 2 hours to take everything apart and get it back together & running again with no problems. All the parts I ordered were exactly what I needed to fix everything. Thank you all !!! Read More... 5 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours Tools: Adjustable Wrench, Screwdrivers
Roy M Saint Paul , VA April 04, 2018 Squealing dryer. Replaced the belt and idler pulley. The job was bigger than I expected. Had to take the whole dryer completely apart, because there wasn't an access panel on the back. Other than that the job went smoothly. Read More... 4 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours Tools: Nut Drivers, Pliers, Screwdrivers
Jeff L Neshkoro , WI May 21, 2019 Appliance: Model MAYTAG MODEL DG 410 Idler pulley noise. Ordered parts for a 25 year old Maytag gas dryer..no problem in getting parts,.the web site for parts are great It cross references to other parts so you can order the parts. or suggestion on what you may need to do..I didn't have to take the dryer totally apart from the front..as if you would repair the drum roller for which I did a few time ..just pull out dryer from wall disconnect the gas and power suppley..open the small 8 x8 panal on backside where the motor is located , take old parts out replace will new parts down. reconnect everything..Than done ..It took me 20 to 25 minutes to do the job..My skill level is very good. If I would get a repairs person to do it. I would have to take the dryer to than and the cost would be over $200. Besides if you have anything that more than10 years old no one will repair it. So I save over $!00.. By doing it myself Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers, Pliers, Screwdrivers, Socket Set
Marty F Walla Walla , WA April 23, 2017 Belt tensioner. Replacement along with belt and drum rollers. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Pliers, Screwdrivers