Lynda B Perrysburg , OH June 08, 2014 Appliance: Whirlpool Washer WFW9600TW00 I wanted to take washer and dryer off the pedestal bases and realized i needed new feet Very simple, just screwed them in, leveled, then tighten bolt. You need a second person to tilt the washer back. Read More... 7 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Adjustable Wrench
Calvin M Cottage Grove , MN April 12, 2020 Appliance: Maytag Washer MFW9700SB0 Washer slow draining or not draining / error codes (suds & f code). Tilted washer backward, supported with jack stands, removed 2 screws holding toe panel. There's a 4" PVC cap, which is actually the drain filter, unscrewed it and removed 2 years worth of garbage. Installed a new seal on drain filter, installed new leveling feet and closed everything back up. works like new..... Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Drew J Dallas , TX September 08, 2020 Appliance: Whirlpool Washer GHW9150PW1 Needed a stacking kit to fit in our new laundry room. My Whirlpool Duet washer and dryer were side by side units with pedestals. When we moved our new laundry needed the units to be stacked. We disassembled the pedestals and ordered the stacking kit and new feet for the washer. Assembly was easy. The screws for the brackets took awhile to catch and finally go into the washer but with some patience all 4 went in. The adhesive pad for the bottom of the dryer went on nicely and fit the exact dimensions. Overall great experience with customer service and easy to install. Read More... Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Pliers, Screwdrivers, Socket Set