Whirlpool 74011142 Range Oven Door Hinge OEM Part

The replacement hinge unit arrived in just two days. The JennAire (Maytag) oven door is fairly typical in that it easily lifts off of the hinge bars. Once the door is off then removing two screws is all that's required to remove the hinge unit from the oven. The new hinge slides up into place and while you hold it up inside of its location putting the old screws back in is very easy. After sliding the door back down onto the hinge bars the oven is as good as new

Installed new hinges.

Replaced the hinges which fixed the leaking problem. Hinges were a little pricey, but did the job.

Removed lower draw from stove. Removed oven door from hinges, by grabbing on both sides of the door with it at the first stop point, and pulling up,and off. Located the 2 hinge mounting screws, and removed the lower ones on both sides as I replaced both hinges. The hinges don't come in a set, and are the same hinges for both sides. I then tried to figure out how I would grab the old hinges to get it out. Reached under, and could feel the hinges, but wasn't confident about removing it, and getting the new one in. Looked underneath, and saw the way the side purses were made, and figured out that if I pull my jenn-air glass top slide-in stove out around 12 inches the spring should be within reach. Removed the top screw, and pulled the old springs out, and installed the new ones. Easy as pie! Was worried about the seal, but that was fine. Was pricing new stoves, but no need to now, and saved myself $2500. Don't know what year the stove is, but I know I can still get parts for it here.

Had to take the side panel off halfway to sneak the old hinge out and replaced that with a new one. The hinge only had two screws so that was easy. I had to take two screws off the front to lift the glass top off. Flipped it over and easily replaced the old element with a new one.