John M Craig , CO November 27, 2017 Appliance: Model MDC40000AWX Problem with detergent cup lid. The foam was shot on the detergent cup lid. Hard as a rock. Causing caking problems, dribble down the inside wall of the door and leaving lumps of detergent. Cut the door in half wit aviation snips and pulled out the two halves. Discovered at this point that the spring had gone soft. Bought one ahead of time, so I was set. Put the spring on the left pin, put the spring pin in the door, slipped the door into place (open) and put the right pin in with pliers. Door snaps open now. Read More... 7 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Pliers
Chris H Ashland , VA July 04, 2015 Appliance: Model MAYTAG NEPTUNE Washer would not go into spin cycle Replaced wax motor switch and door lock switch. Read More... 5 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers
John F M Fullerton , CA December 24, 2022 Just needed to replacie the detergent door on the washing machine. Replaced the Dispenser Lid and attached some Hinge Pins.. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Sherry S Aurora , CO August 27, 2021 The lid hinge was broken on the soap dispenser Bought a new lid for the soap dispenser. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes
James M Colorado Springs , CO December 16, 2015 Detergent dispenser lid deteriorated and broke off of my maytag front load washer Replaced lid and hinge pins. Needle nose pliers helped to push the short hinge pin through the lid hinge and into the dispenser bezel. Good as new. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Pliers