Christian T Seattle , WA October 04, 2015 Appliance: Maytag 30" Slide-In Downdraft Range Gas On Glass JGS9900BDS15 Touchpad stopped working After doing much research online, I found out that the Touchpad on the JennAir downdraft gas range JGS9900BDS is very prone to "breaking." All my neighbors who has this model has reported that the touchpad stopped responding after a few years. Replacing was fairly simple. 1. Turn off the electricity to the range at the breaker 2. Pull the range out by an inch or two 3. On each side of the control panel, remove the screws. 4. Open the oven door and remove the 4 hex screws under the control panel 5. Remove the gas knobs and unscrew the 4 screws in it 6. Pull the control panel out gently 7. Using a sharpie, label 1-7 on the circuit board as well as the wires (I used masking tape on the wires) 8. Gently remove each wire connection 9. Unscrew the circuit board and replace it on the new control panel 10. Reverse the process to attach all the cables and screws (remember to remove the masking tape if you used it). Hope this helps. Read More... 6 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Terrence M Chesterfield , MO June 13, 2022 Loose knob. Ordered and replaced burner knob. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes
Glenn S Spring Creek , NV September 17, 2018 Burner knobs were cracked and needed to be replaced. Bought new ones from AppliancePartsPros.com Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes
Donna C Park Ridge , IL January 23, 2015 Appliance: Model JENN AIR STOVE Needed new knobs Just ordered the knobs from your website, which was very easy to use. When they arrived (very fast) just put them on. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes
Maryann J Tuckahoe , NY September 18, 2017 Knobs on stove needed replacing. Ordered four new knobs. Because of the stove model, the four knobs are three different parts. Three of the knobs fit and work fine. The fourth knob had the information printed on it, off by 180 degrees (in positioning, not temp). Hence, if the knob fit correctly, it pointed to the floor when in the off position. Yet, when turned to the off position-toward the ceiling, the flame was pretty high. The other three point to the ceiling. No flame. New knob being sent. Holding my breath. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes