Thomas M Sequim , WA October 03, 2014 Worn over gasket and knobs We recently purchased a house with Jenn-Air appliances. The previous owner had used something to clean the knobs on the stove that removed the imprint. Ordering these was easy, they fit with no problem and are manufacture initial product quality. Very Pleased. The only suggestion I would have is to provide instructions on how to install the oven door gasket. I have not attempted that yet but will soon. Read More... 4 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes
Steven F Kenner , LA January 08, 2018 Jenn air downdraft slide in range completely dead other than surface burner units I changed the control board initially; and the clock started working, along with a least a beep from some of the other control buttons, but no luck on the oven. Changed the front control panel and regained full functionality. Both parts with shipping less than $550; rejuvenated an appliance that would have cost $3500 to replace. Both repairs took less than 30 minutes each. Also changed oven gasket and a few of the knobs. Very easy. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
Kimberly G Royal Oak , MI October 03, 2015 One of my burner control knobs was stripped I ordered a new knob from your website. Your site was easy to figure out and the photos of the actual knobs as well as the compatibility reference was very helpful. I just popped the new knob onto the place it belonged and everything is fixed! Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes
Brian L Ponchatoula , LA December 18, 2019 Front right dual burner quit working tested power to the control that was present and checked for power coming out of the control and no power was present to burner Part was very easy to replace, it only took 15-20 minutes. Worked great after that. Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers, Screwdrivers
Philip C Centerport , NY January 15, 2018 Appliance: Model JENAIR ELECTRIC 2007 Outside burner not lighting interior element too hot Disconnect power removed 8 screws to remove glass cooktop, disconnected three wiring harnesses. Swapped burner. Two screws and two connections on back of switch. Replaced everything. Success. Read More... Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Nut Drivers, Screwdrivers