Dedra G Sanford , FL February 29, 2016 Appliance: Model MH7140XFQ-1 Crack across lower portion of handle and bottom corner of door frame where screw attaches First, just for safety sake, unplug the unit. I took the three screws out of the latch end of the door and pried both the inner (black) frame off and the outer (white frame) being careful not to crack the inner frame as I wanted to reuse it. I removed the screws holding the old handle on and reused them to fit the new handle to the new frame. I then had to take the glass from the broken frame, clean it, and reuse it on the new frame. You need clear silicone sealer to hold the glass firmly in place after you pop it in place in the frame (it doesn't slide in). I waited 24 hours for the sealer to cure before reassembling the frames to the door. I used a small putty knife and a small flat head screwdriver to pry the frames off. Again, being careful with the inner frame since I didn't order a replacement. The three end screws and the two handle screws require a phillips head screwdriver. The actual work time was not very long and putting the frames back on was immensely easier than getting them off. Both processes take patience and finesse. Read More... 8 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
Steve C Buckeye , AZ March 31, 2014 Mircowave handle You guys said my part would get here in 2 days, it got here in 2 days. No problem with the part, fixed my microwave in 10 minutes. Thanks! Read More... 8 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Wayne M Joliet , IL October 22, 2016 Appliance: Model WHRILPOOL MH1141XMQ3 The microwave door and handle were broken I received the parts from parts pro within 3 days and everything fit perfectly nd all went well Thanks Parts Pro Wayne Mazur Joliet Il Read More... 5 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Todd C Henderson , NV March 21, 2019 The plastic frame and handle was broken Ordered the new parts and installed them! Easy! Read More... 3 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Kristapher G Crestview , FL October 08, 2015 Broken handle Open the door and remove the three door cover retaining screws with a electric screw driver Phillips head next I poped the microwave door cover off with a large flat head screw driver taping it gently with a small hammer by the metal door hinges I then used my hands to pull the rest of the cover off. With the cover removed I removed the two handle retaining screws with a Philips head screwdriver located on the inside of the door cover and removed the handle. I then positioned the new handle in place and installed the 2 screws with a electric screwdriver pop the cover back on starting with the side closes to the hinges and reinstalled the three door cover retaining screws. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers