Whirlpool 4342528 Oven Igniter OEM Part

The oven would not heat up but the broiler and stove top burners all worked so I replaced the igniter. The part arrived quicker than I expected - one day with regular shipping - and the repair also went much quicker than expected. After accessing the igniter I was able to unplug the plastic modular connection. Instead of pulling the oven out from the wall - which would have been a huge pain - I was able to reach the plug by removing the bottom storage drawer under the oven. From there it was just a matter of routing the wiring and attaching the new igniter. Just be advised that the new igniter will need to 'burn off' that new smell. I don't recall having a DIY repair go any easier. The only issue some people may have with the repair is be able to reach to the very back of the oven for access to the ignitor and getting on the floor for the disconnection/connection of the new plug.

Replaced the glow plug with ease. A few screws and an electrical plug tie in and the job was finished. It took no longer than 10 minutes.

I found your website and instructional videos via an internet search engine, and after seeing that probably the oven igniter was a likely cause of the problem, I watched your video on how to replace it. That gave me the confidence to try it, so I bought the part from you. One day later it arrived, and the next day I replaced the igniter. That evening my wife was baking again. Thank you! I do suggest that you add a diagnostic step to the video. In my case, I should have tried the broiler first. If that igniter wouldn't glow either, then it might be the control box that was faulty, and in that case I wouldn't have bought the igniter yet. In my case, after the part arrived, I thought to check the broiler igniter and it glowed fine. This gave me greater confidence that the problem was the lower (bake) igniter.

After finding the replacement part on AppliancePartsPros.com it arrived within 2 days and I used YouTube to find your do-it-yourself installation video. It was a fairly straightforward and simple process that took about 1/2 hour from the time I unplugged the electricity and switched off the gas main. Thanks AppliancePartsPros.com!

My wife said "the oven doesn't work". So I observed that the igniter never glowed after the oven was turned on for preheat. I unplugged the oven, removed the bottom drawer, reached in and unplugged the clip to the lower igniter, and used a multimeter (set on Ohms) to check the resistance in the igniter itself, and confirmed there was no reading--meaning circuit broken in the igniter. I ordered the igniter, it came in 2 days (fantastic shipping!) and replaced it (2 8mm bolts). Turned the oven on to preheat and immediately saw the glow, then the gas came on and the oven fired up. Good to go!