Randall W Austin , TX May 13, 2017 Appliance: Maytag Undercounter Dishwasher MDBH985AWS10 My dishwasher had slowly but finally stopped working The LED lights and the switches had begun to stop working, one by one, for a while until finally the dishwasher would not start and run at all. Thanks to Appliance Parts Pros.com, I was able to be confident to order the right part and fix it. The only tool needed was a screwdriver with a torx drive bit. If you are uncomfortable doing things like this just take photos as you take things apart. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers
Robert F Lawrenceburg , IN March 20, 2015 Appliance: Maytag Undercounter Dishwasher MDB8851AWS10 On off switch on the control panel stopped working After doing some searching I found owners having similar problems with their on off switches not working. Most had noticed after opening up the door panel and seeing burn marks on the ribbon cable from the panel control. After doing the same on my unit I notice burn marks as well. The remedy seemed to be replace the panel control so I ordered a replacement. When it arrived installed the new panel and that fixed the problem. The dishwasher is now working like new! Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers, Socket Set
James P Martinez , CA April 08, 2016 The control panel needed to be replaced; buttons were not responding Replaced the control panel. Easiest thing I did all day! Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers, Screwdrivers
Michael H San Jose , CA January 13, 2017 Appliance: Maytag Undercounter Dishwasher MDBH985AWS10 Display and buttons became intermittent and eventually stopped working Replaced the control panel, easy peasy, required torx wrench Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers, Screwdrivers
Brian S Newport Beach , CA October 25, 2015 Burn spot in panel controller wires After figuring out the several of the parts slide out after removing bolts, things went smoothly. Entire repair only took about 15 minutes. Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers, Screwdrivers