Crystal B Bonner Springs , KS September 28, 2018 Broken dishwasher control board/ user interface. Replaced user interface Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers, Screwdrivers
Gerald M Redington Beach , FL August 07, 2015 Would not start no lights on control panel Installed new panel from Appliance Parts Pros. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Nut Drivers, Screwdrivers
Joseph F Saco , ME June 10, 2015 Appliance: Maytag Undercounter Dishwasher ADB3500AWB0 Machine would not start some control panel buttons would not react I tested the door switch, and finally pulled my control panel out, and noticed either breaks, or severe corrosion on the end of the ribbon cable closest to the panel. I ordered the part from this site, and it was a quick rough in to test, then I made it permanent. All it took were some hex wrenches (although the door probably uses Torx screws), and a 1/4" socket/driver Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers
Mark S Belle , MO March 20, 2015 Appliance: Model ADB2500AWB37925849LL The buttons on the front stopped working right causing problems starting the dishwasher First I ordered a new Control Panel from Appliance Parts Pro dot com. Then on a dark & rainy day the parts were delivered... It only took about 1 and a half days for it to arrive! This is not my first rodeo when it comes to repairs. Changing out the parts was a fairly simple task if you take your time... I removed the screws (you needed a star type bit) holding the inner panel of the door (about 9-11 screws) and gently raised it up (there are wires to the front panel so be careful) to get to the screws holding the "Control Panel" on the door. Removing the screws with a nut driver you can now remove the control panel and unplug the only wire going to it. NOTE: Make sure you look at that flat ribbon wire and remember how it goes into the plug in the control box. Plug in the flat ribbon wire, from the new part, into the control box and then reverse the processes to assemble the door. Not a hard repair if you take your time. ONLY ONE WIRE TO DISCONECT AND CONECT! Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers, Screwdrivers