Tyler O Salt Lake City , UT May 19, 2014 Appliance: Maytag Undercounter Dishwasher MDBTT60AWW0 Dishwasher wouldn't start For a few years most of the lights on my dishwasher weren't working. It was irritating not knowing exactly what settings I had but it still cleaned the dishes. Then suddenly it wouldn't start at all. I knew it was an control problem and I assumed it was the control circuit board though I also thought it could be the control panel. I was about to buy a new board but then thought to do a search for "control board vs. control panel". Thankfully I came upon the AppliancePartsPros.com forum where I discovered this was a common problem with the control panel. I ordered a new panel (not cheap but cheaper than a new dishwasher) and when it arrived it was simple to switch out the old one. It works like new. Read More... 14 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers, Screwdrivers
Robert S Buford , GA October 25, 2014 Several lights weren't working and dishwasher would not come on I found the ribbon cable from the controller to the control pad failed internally and the traces were broken. After replacing the control pad & ribbon cable, the dishwasher works normally. Read More... 3 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers
Julian A Dothan , AL July 18, 2015 The control panel had broken screw mounts that caused the door to not open properly I replaced the control panel and the dishwasher works fine now. It only took about 20 minutes to repair the dishwater. It works fine now. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers
Abraham C Chardon , OH March 15, 2014 Rinse light stayed on, usually could not start wash Replaced panel by unscrewing inside of door panel andr then unscrewing cover from control board. hardest part was inserting new flex cable into control board, but after taking the cover off the board it was easier to get a good angle. need a Torx bit for the screws. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
Cecil G Wilmore , KY February 10, 2017 Appliance: Maytag Undercounter Dishwasher MDBTT60AWB3 The start button on control panel wouldn't work After pricing new dishwashers decided to replace the panel. I ordered it on a Monday morning had it Tuesday afternoon. Removed the front took old panel off put new one on. Dishwasher was in operation that night. Cost was about a third of new washer. Read More... Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Socket Set