Whirlpool WP37001132 Dryer Drum Felt Seal OEM Part

After replacing thermal fuse once and having it fail a second time, I had to dig a little deeper to uncover the problem. I checked for blockage in the vent but everything was clear. I did, however, find that the drum had some up and down play in it. After closer inspection, I could see that the front drum seal was actually worn to the point that I could see a gap between the seal and the drum. I figured that the gap in the seal was letting air in and not letting sufficient air flow through the heater unit. By not letting enough air flow through the heater unit, the heat increased to the point of activating the thermal fuse. The limit thermostat was defective or it would have stopped the heater from getting to the point of blowing the thermal fuse. The dryer may have been operating off the limit thermostat and not the cycling thermostat as it is intended to. This may have caused the limit thermostat failure. I ordered the front and rear felt seals, new drum glides and felt pads, and adhesive for the seals. I was totally impressed that the parts were here two days later and allowed me to install them that weekend. After letting the adhesive set for a day, I put everything back together and monitored the heater, the limit thermostat, and the cycling thermostat with multimeters while the dryer was in operation. The dryer was now working off of the cycling thermostat. Another bonus was that the dryer ran a lot quieter. Thank you Appliance Parts Pros for your prompt delivery and ordering help.

I went on line and purchased all of the possible parts that could be worn out. I spent less than the service guy wanted to show up...The online videos were spot on. Two hours and it works like new! One of the best values on the Internet!

Replaced them.

Removed tattered felt seal and replaced it with new one

1. I watched your videos (twice) to see disassembly steps and techniques 2. Disassemble dryer to diagnose troubles. 3. Found that the drum was hitting the top of the blower housing and that new felts and glide pad felts should fix it. 4. We accidently broke off the plastic air duct in handling, so I ordered one of these as well. 5. The parts arrived in 3-4 days. 6. We followed the instructions in the videos, which are well detailed and 7. The machine is now very quiet and operates perfectly! Thanks!