Joe Ray S Albuquerque , NM January 19, 2015 Appliance: Model MAW TAG FRONT LOADER. ....4000AWW Washer would not spin in high speed at end of wash Replaced the motor wax door lock switch and the door lock spin enable switch. Read More... 12 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
Ronald S National City , MI October 19, 2014 Appliance: Model ON BACK OF UNIT No spin cycle door would not lock Changed wax motor but did not work.changed circuit board and solved problem Read More... 8 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers, Screwdrivers
Jeff B Crofton , MD June 17, 2017 Appliance: Model NEPTUNE STACKABLE Would not perform the final high speed spin. Changed out the wax motor and the door switch. Works perfect now. Thank you. Read More... 6 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers, Pliers, Screwdrivers
Todd M Oakland , CA January 11, 2016 Appliance: Maytag Stacked Washer MHW2000AWW Maytag neptune didn't spin but washed First tested the control board above the dryer in my stacked Neptune. Q6 Triac and R11 resistor looked and tested fine. Then tested micro switches above washer door. One was bad. replaced it and the still working original wax motor for good measure. Total repair including tests about an hour. But I've had this apart before... Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Nut Drivers, Screwdrivers
Nolan W Dripping Springs , TX June 28, 2016 Finish wash no spin out excess water Verified that the old spin enable switch did not close the circuit when pressed. Compared that to new switch in hand. Once switched, replaced top panel, front panel and door. Started washer and all was good. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers, Screwdrivers