Al S Lake Elsinore , CA July 13, 2014 Appliance: Model 110.24086200 During wash cycle the washer would stop for about three to four seconds and start up again spin for about three seconds and start the cycle of stop three stater for four and so on I unplugged the lid switch behind the control panel, bypassed the switch with a wire connected from the neg and positive terminal where the switch would normally plug into and ran the washer through a complete cycle with no problem.....hence the lid switch was faulty. I assume the faulty switch was " telling " the control panel someone was opening and closing the lid, causing the washer to stop and start.....Damn I am good!!!! Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers, Screwdrivers
Mark E Casper , WY October 07, 2015 Appliance: Whirlpool Washer - Direct Drive GVW9959KL1 Ls code on calypso washer Pulled off top control panel to access retaining screws on lid switch. Pulled old switch off and replaced. Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers, Pliers, Screwdrivers