Micheal W Millville , UT April 11, 2014 Water level control wouldn't work I replaced it and the new one fit perfectly. reassembled and fired it up. Worked as desired, like new... Read More... 14 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers, Pliers, Screwdrivers
John W Manhattan Beach , CA April 24, 2016 Appliance: Whirlpool Washer WTW5500SQ0 Water level switch broke off in my hand Looked online at your site, found the video on how to fix, ordered the part, and the repair went GREAT!!!!!!! Read More... 8 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers, Pliers, Screwdrivers
Walter W Clovis , CA November 06, 2016 Water level selector switch couldn't be turned then unfrozen but water level was always the same Purchased and installed the water level switch kit. Watched the on-site repair video several times, then with laptop nearby went through the repair step by step. Even vacuumed under the washer while it was pulled out. The only problem was not kit related; the video shows the repair in a spacious studio while the actual repair was in a cramped laundry room. Your contortions may vary. Be sure to gather your tools before hand and have them within reach. Wear gloves, metal flanges can can hang out where you can't see them. Read More... 6 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Pliers, Screwdrivers
Gary K High Point , NC November 01, 2014 Appliance: Maytag Washer ATW4475TQ0 Agitator would not work Ordered new direct drive kit took about 1hr to replace and works perfect! Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers
Don S North Ridgeville , OH June 14, 2021 Appliance: Maytag Washer MTW5700TQ0 Water level switch was impossible to move from the first position and then after a while from the "medium" position as well. Because I had replaced the timer on the washer a couple of years ago I was familiar with how to access the controls having watched the "AppliancePartsPros" video at the time. I ordered a replacement "Water Level Switch" and replaced it within 5 minutes. I did short-cut the repair in that I did not replace the hose to the switch. I trimmed about a half inch off the end that had been attached to the old switch. Other than not being able to turn the old switch from "small" and "medium" positions it worked fine. The new switch works as it should in all positions and is easily switched from one position to another. Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers