Shawn H Laramie , WY March 22, 2015 Dryer heating element would not heat Use multi meter to test element and motor safety switch ,3 high limit switches all tested good. then we tested across timer switch and it was in an open circuit. all test were unplugged using ohm tests. tests confirmed it was a timer. dryer works like it was new being 20yrs old... Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers, Pliers
Arthur L Owings , MD January 26, 2017 Kenmore drier: end of cycle buzzer "on" constant and starts without pushing "start" button It was obvious that the timer and the start switch had malfunctioned so it became a matter of getting the correct parts and installing them. The repair as simple and this site was helpful. VWTECHEDITOR Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers, Screwdrivers
John L Bessemer , AL November 04, 2017 Would not run. New thermal fuse. While working on it I checked contact tips on timer they were burnt up so I ordered new timer while at it. Door switch had been stuck closed for a while so I ordered a new one of them. Read More... Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers
Gerald L Greensburg , IN October 12, 2015 Clothes dryer would not start Replaced the selector switch Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers, Screwdrivers
Edward S Marietta , OH April 30, 2016 Appliance: Model 96573213 Clothes dryer buzzer would not shut off dryer would start without pushing start switch Installed new timer and start switch on advice from Appliance Parts Pro. Read More... Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Nut Drivers, Screwdrivers