Robert N Singer Island , FL August 01, 2016 Kenmore gas dryer timer did not advance (16 years old) Part ordered installed (easy), fixed problem for two loads of wash. Dryer then ran but did not heat. Researched on web and tested thermal interrupt fuses. Ordered (easy install) and now all is well. In the course of the fix it became apparent that the exhaust vent had rotted open on the portion resting on the floor. This was blowing hot air into and below the dryer and opened the fuse. All fixed, all is well. appliancepartspros.com Rated as a ten!!!!! Read More... 3 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Nut Drivers, Screwdrivers
Richard M Monroe , NY July 18, 2014 Appliance: Maytag Gas Dryer MGDC400VW0 The timer would not advance also gas valve would not operate correctly I ordered a timer and two solonoids for the gas valve. Problem solved dryer backin service. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers, Screwdrivers
Esther V Covina , CA July 30, 2014 The dryer timer would not move so the setting would stay on until you stopped it this caused several 'burnt' shirts I viewed the video on youtube from appliance parts pros. It looked like my problem. I ordered the piece. The piece matched up with the exception of a couple of extra wires that my timer on my dryer had, that we easily just matched up. First try at drying and it worked. Extremely simple and took only about 15 minutes. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Socket Set
William Q Ottawa , WV September 09, 2014 Timer burned up Replaced timer Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers, Pliers