Parts for Frigidaire FAL123S1A1: 06 - Window Mounting Parts

Replace worn compressor mounting grommets to stop excessive vibration and noise. Fits most air conditioner and heat pump models. Simple DIY fix.

This overload protector is a safety device mounted on the compressor that cuts power when the motor draws too much current or overheats. It prevents damage to the compressor by shutting it down before excessive heat or electrical load causes failure. Replace this part if the compressor won't start, cycles on and off rapidly, or if the unit shuts down unexpectedly during operation.

This terminal-cover gasket seals and cushions the appliance's electrical terminal cover, helping protect wiring and connections from moisture, dust and abrasion. It restores a secure fit for the cover and helps maintain safe operation. What it does:

• Creates a sealed barrier around the terminal cover to reduce moisture and debris intrusion
• Cushions the terminal cover to prevent chafing or movement of wiring and connectors
• Helps reduce risk of arcing by keeping cover seated and terminals covered
• Useful when the existing gasket is cracked, warped, missing, or no longer forms a tight seal

• Disconnect power to the appliance before servicing electrical components
• Remove the terminal cover and clean mating surfaces of debris and old gasket material
• Press the new gasket into place, ensuring it seats evenly around the cover perimeter
• Reinstall the terminal cover and restore power; inspect for secure fit and any exposed wiring

Fix an AC compressor that won't start or struggles to turn on with this start assist kit. Helps older units start reliably. DIY-friendly installation.