Parts for Frigidaire TMT116E1B0: 05 - Wrapper / Body Parts

This air intake duct directs incoming air into the appliance's airflow path to maintain proper ventilation and performance. Replacing a damaged intake duct restores airflow and helps components run cooler and more reliably. What it does:

• Channels fresh air into the appliance's ventilation system for consistent airflow
• Helps prevent restricted airflow that can cause long cycles or reduced performance
• Reduces strain on blowers and motors caused by leaks or collapsed ducts
• Limits dust and debris entry at the intake area when installed correctly

• Disconnect power (and gas supply for gas appliances) before starting any repair.
• Remove surrounding panels or covers to access the intake; keep fasteners for reassembly.
• Check mating surfaces and seals; replace any worn gaskets or clips to ensure a snug fit.

This is a replacement screw used to secure appliance components and panels so assemblies stay stable and aligned. It provides a straightforward fix when a mounting fastener is missing, stripped, or damaged. What it does

• Secures panels, brackets, or trim to prevent movement and vibration
• Stops rattling or loose parts caused by missing or damaged screws
• Restores proper fit and alignment of the affected assembly
• Works wherever the OEM-designated screw of this size and thread is required

• Turn power off or unplug the appliance before working on electrical areas
• Use the proper-size driver to avoid stripping the head
• Start threads by hand, then tighten until snug — do not overtighten
• If the original screw is corroded or the hole is damaged, inspect mating parts for repair before installing

A replacement screw fastener that secures appliance panels and components to restore proper fit and reduce rattling. Use this exact replacement to refasten loose parts and keep assemblies aligned for dependable operation. What it does:

• Secures panels, brackets, and trim to prevent movement and vibration.
• Common replacement when screws are missing, stripped, or damaged.
• Helps stop rattling, loose panels, or parts that shift during use.
• Uses the original attachment point so the component fits and functions as intended.

• Disconnect power or gas and follow appliance safety procedures before servicing.
• Use the correct screwdriver or bit to avoid cam-out and damage.
• Do not overtighten — snug to manufacturer torque to avoid stripping threads or cracking parts.
• Replace with the identical part number for fit and function; replace the mating fastener or insert as needed.

The Grease Filter is an OEM replacement part for Frigidaire microwaves. It traps grease-laden smoke and particles released from cooking. Color: silver. Measures about 6 inches wide by 8 inches deep.

Causes of a bad grease filter can include clogging from accumulated grease and debris, physical damage from cleaning or handling, or wear and tear over time. A clogged or damaged filter can reduce the efficiency of the range hood, leading to poor ventilation and potential damage to the range hood motor.

Symptoms of a bad grease filter include:

• Reduced airflow or suction
• Excessive smoke or odors during cooking
• Grease buildup on kitchen surfaces
• Visible damage or clogging of the filter

This OEM replacement is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore models.

This is a replacement mounting screw used to secure panels and components in compatible Frigidaire appliances. It restores proper fit and helps prevent rattles, loose panels, and parts that shift during operation. What it does:

• Fastens trim, panels, brackets, or controls to the appliance frame
• Restores secure attachment to reduce vibration, noise, and movement
• Replaces stripped, missing, or corroded screws that prevent proper assembly
• Works wherever the OEM screw with this part number is specified

• Disconnect power to the appliance before beginning any repair
• Use the correct screwdriver or bit to avoid stripping the head
• Tighten until snug—do not overtighten to avoid stripping threads or damaging parts
• Keep removed hardware organized and compare parts to the old screw for correct fit