Yard Machines Engine Parts

This is a complete carburetor assembly for a lawn and garden equipment engine. The carburetor mixes air and fuel in the correct ratio for combustion, enabling the engine to run smoothly. Replace this carburetor if the engine is hard to start, surges, stalls, runs rough, or if fuel is leaking from the carburetor body.

This genuine OEM Part is a choke temperature control rod for lawnmowers. The choke temperature control is the metal piece that regulates the choke temperature allowing for it to function properly within a lawnmower. If the choke function is no longer working efficiently, it might be time to replace the choke temperature control. Luckily, replacing this part is a simple repair.Before beginning, make sure the engine is cool to avoid getting burned. Locate the old choke temperature control rod and remove the screws to the mounting assembly that hold the rod in place. Once removed, lift the old choke temperature control out and away from the mower and set it to the side. Replace with the new control rod and secure the mounting screws. Start up the mower to see if the choke function is working properly. If it does, the installation was a success. This replacement part is sold individually and is compatible with MTD brand lawnmowers.

Replace a cracked or broken ignition coil on your walk-behind lawn mower. This part sends power to the spark plug and may need replacement if damaged.

Replacement fuel tank for lawn mowers. Mounts to mower exterior to hold fuel supply. Replace if cracked, leaking, damaged, or missing. Direct fit part.

Carburetor insulator gasket installs between the carburetor and engine block. Replace if cracked, deteriorated, or missing to prevent air leaks.

Replacement oil drain plug for small engines on outdoor power equipment. Needed when original plug is stripped, cracked, or leaking. Installs at oil pan.

Carburetor rebuild kit for snow thrower engines. Includes gaskets and components to restore carburetor function when worn, damaged, or leaking fuel.

This genuine OEM starter handle is sourced directly from the manufacturer. The starter handle is the visible part of the starter rope component of the pull-start system. This starter system is standard on outdoor lawn and garden equipment. The starter handle is attached to the end of the starter-rope by means of a pass-through hole on the handle. The rope is pushed through the hole, tied, and pulled back into the handle to conceal the knot. The starter handle is made of durable plastic. The heat from the sun and repeated daily use may cause the handle to weaken and break. Cracked starter handles can become a safety hazard. Gripping and pulling a cracked handle can cut skin. Broken handles can also be hard to grip, making it difficult to get a good pull on the starter rope. Thankfully, replacement is simple and no tools are required. Make sure the spark plug is out of the machine to prevent accidental engine starting. Push the rope back up through the handle. Untie the knot but do not let the string go; push it up through the hole in the new handle and tie a knot in the end. Reinstall the spark plug.The starter handle is sold as a single unit. It is designed for leaf blowers, wood chippers, and small engines and is compatible with MTD, Cub Cadet, Troy-Bilt, and Yard Machines.

Replace your snow thrower's engine dipstick assembly. Essential for checking oil levels. Order this direct replacement for cracked, missing, or damaged dipsticks.

Replace your snow thrower's choke knob if the original is cracked, broken, or missing. Installs on the engine control panel for manual choke operation.