I sent question yesterday about bake and broil not getting hot. I have an electric oven and burners work fine. is the Y0314907 a likely problem for my broil and oven not getting hot?
Answer Hello Mike. Sorry about that the model number used pulled up a gas unit. On your model, check and make sure there is 240 volts to both elements. With both failing at the same time, it leads toward a voltage issue with the unit. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html
I get F-4 code when I turn on temp control for oven and oven won't start.
Answer Hello Russ,
F4 Error code indicates a shorted oven sensor circuit. You will want to test the wiring to your oven sensor circuit. Also test sensor. Sensor should ohm out at approximately 1100 ohms at room temperature.
I have an Amana electric stove model ARR630LL and I started getting an F3 reading on the clock. I did some research and found out that the F3 meant a faulty heat senser. I went to the local parts house and got a new senser (part # y0314907) and installed it. The same thing is still showing on the clock (F-3). What next???? Roger
Answer Roger, A new oven temp. sensor should have a resistance of 1050 to 1100 ohms. Since the sensor is new, you'll need to check the wiring from the sensor connection up to the ERC/clock, make sure there are no broken wires, or damaged insulation and no loose connections. You may want to disconnect the sensor harness from the ERC and check the resistance across the wires in the connector. if you have the correct resistance, the ERC/Clock Y0309441is at fault