Parts for Ge GXRM10GBL: 01 - Filter Assembly Parts

Replacement 1/4" tube nut for water filtration systems. Secures tubing to fittings and couplings. Needed when original is cracked, stripped, or missing.

This tube T fitting connects three sections of refrigerator tubing to route water to the dispenser or ice maker. It provides a compact, plumbed junction for matching 1/4" and 3/8" tube sizes and helps restore proper water flow. What it does:

• Joins one 1/4" and two 3/8" water lines into a single T-shaped junction for dispensers/ice makers
• Re-establishes a sealed connection when a split or damaged tube junction causes leaks
• Helps restore water delivery to the dispenser or ice maker when the plumbing junction is the issue
• Used where a compact, inline tube junction is required in the refrigerator plumbing

• One tube T fitting — only the fitting is included

• Turn off and disconnect the refrigerator's water supply before replacing plumbing fittings
• Use proper tubing sizes and push/flare fittings as specified by the appliance; fit before finalizing connections
• Tighten fittings securely but avoid over-torquing; after installation, slowly restore water and check all connections for leaks
• If tubing or surrounding components are damaged or corroded, replace them to ensure a reliable seal

Screen cone is a replacement cone-shaped screen that helps keep lint and debris out of the appliance's drain and pump area, reducing clogs and helping protect pump components from wear. What it does:

• Traps lint and loose debris before it reaches the drain and pump assembly.
• Helps maintain proper draining and reduces the chance of recurring clogs.
• Reduces stress and potential damage to the pump impeller caused by foreign debris.
• When worn or missing, common symptoms include slowed draining, recurring clogs, or unusual pump noise.

• Disconnect power to the appliance (unplug or shut off breaker) before accessing the pump/drain area.
• Turn off water supply if required by your model and drain remaining water before removal.
• Replace the old screen cone with the new unit, ensuring it seats fully in the housing; no special tools are typically required.

Reverse osmosis membrane cartridge restores filtration performance by removing dissolved impurities. Replace when water clarity or taste declines. Verify compatibility with your RO system model before ordering.

Mounting bracket for water filtration systems. Secures filter housing to wall or cabinet. Replace if cracked, bent, or missing to properly support your filter.

Creates watertight seal between sump housing and water filter. Replace when experiencing leaks or during filter changes. Confirm fit with your model number.

Pre & post reverse osmosis filters.

This countertop-mounted faucet assembly replaces the dedicated dispensing faucet on select under-sink filtration and reverse osmosis systems. It restores smooth on/off control and a clean chrome look while providing a reliable dispensing point for filtered water at your sink. What it does:

• Provides a dedicated faucet and shutoff for water from the filtration/RO system
• Helps address drips at the spout or leaks around the base from a worn faucet
• Replaces faucets with broken or hard-to-turn handles or wobbly mounting
• Mounts in the existing sink/countertop hole used by the original faucet

• One chrome-finish faucet assembly

• Turn off the feed water and tank valve; open the faucet to relieve pressure
• Place a towel or pan under the sink; disconnect tubing from the old faucet
• Remove mounting hardware, lift out the old faucet, and clean the mounting surface
• Set the new faucet, reconnect tubing per system instructions, tighten hardware, and check for leaks before use

Low water pressure or no water flow to your filter? This saddle valve supply connects your water line to the filtration system. Straightforward install.