Parts for Thermador GCT24GD: 01 - Griddle Parts

A replacement hex nut that secures components to appliances and restores proper fastener retention. Use this OEM-design nut when a factory nut is missing, damaged, or stripped to stop movement and restore secure fitment. What it does:

• Secures brackets, panels, or assemblies to prevent loosening or rattling
• Replaces stripped, worn, or missing nuts that cause loose parts or vibration
• Helps maintain alignment of connected components for reliable operation
• Prevents further wear or damage caused by unsecured fittings

• Turn off power and disconnect the appliance before accessing fastener locations
• Use the correct socket or wrench to avoid rounding the nut; hold mating bolt steady
• Do not overtighten; tighten to a snug fit consistent with the original hardware
• If threads are damaged, replace the bolt or mating component rather than relying on a new nut

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.

The Bake Igniter is an OEM part for Bosch wall ovens and ranges. Located at the bottom of the oven cavity, it generates the radiant heat needed to initiate the bake burners.

Causes of a bad bake igniter can include failure of the delicate calrod-style heating element from prolonged high-temperature exposure over time.

Symptoms of a bad bake igniter include:

• Inability to ignite or maintain ignition of the bake burners
• Improperly or unevenly heated oven cavity
• Cool or cold spots appearing on bake results
• Igniter glows, but fails to ignite

This genuine OEM Bosch part is also compatible with Thermador, Gaggenau and select Kenmore models.

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.

This gas pressure regulator controls and stabilizes incoming supply pressure to the appliance manifold, helping ensure consistent burner flames and reliable ignition. Replace if the original regulator is sticking or no longer maintaining correct pressure.

• Regulates incoming gas to the appliance's rated manifold pressure
• Helps maintain even flame height and proper combustion
• Supports reliable burner ignition and reduces flame-out from pressure swings
• Common symptoms include weak or uneven flames, yellow tipping, burners not lighting or not staying lit, or flames that are too high

• Disconnect electrical power and shut off the gas supply before servicing
• Observe the flow-direction arrow; install with outlet toward the appliance manifold
• Use approved gas-rated thread sealant on male threads only and leak-test all joints with a non-corrosive solution after installation