Parts for Maytag MEDE200XW1: 01 - Top And Console Parts

White dryer top panel that covers the drum and internal components. Replace if cracked, damaged, rusty, or worn from heavy use or chemical spills.

Structural bracket that secures components inside your dryer. Replace if bracket is rusty, bent, broken, or missing to restore proper support and alignment.

This is a single replacement screw used to secure appliance panels and components. It restores proper fastening to help eliminate looseness and rattling and keep parts aligned for safe operation. What it does:

• Secures trim, panels or internal components to maintain proper alignment
• Prevents rattling or vibration caused by loose fasteners
• Replaces missing or stripped screws for safe, reliable fit
• Works wherever the OEM screw specification and fit match the original

• One screw as shown

• Disconnect power and/or gas before accessing internal components
• Use the proper driver size and avoid over-tightening to prevent thread damage
• Verify correct screw placement against the appliance's service diagram

The Knob is an OEM component specifically designed for Whirlpool electric dryers. Located on the control panel, the knob allows for the selection of desired drying time, temperature, or fabric care settings. Its sturdy construction assists millions of adjustments over the appliance's lifespan.

Causes of a bad knob can include normal wear from continuous rotation breaking down grease on internal mechanisms. Over-tightening during installation may crack the plastic.

Symptoms of a bad knob include:

• Difficulty selecting options or inability to turn  
•  Knob slipping out of set position during drying  
• Loose, shifty, or jittery feeling during adjustment
• Cracked or broken casing tabs exposing internal parts

This OEM Whirlpool part is also compatible with KitchenAid, Maytag, Amana, Roper, Admiral, and some Kenmore dryers. 

This screw is used to secure the handle end cap to the center of the door. The screw size measures 8-18 x 1/2 inches.