Parts for Maytag LCRE683: 02 - Control Panel Parts

This part has been discontinued by the manufacturer and is no longer available.

Control knob that replaces a damaged or missing appliance dial to restore simple, reliable selection of temperature or cycle settings. Provides a secure grip and clear position control for everyday use. What it does:

• Replaces cracked, worn, stripped, or missing control knobs so you can select settings reliably.
• Mounts on the appliance control shaft to allow accurate pointer alignment and selection.
• Reduces slipping, spinning, or inconsistent selection when turning the dial.
• Restores the user interface so controls are easier and safer to operate.

• Disconnect power to the appliance before servicing controls.
• Most knobs simply pull off the control shaft and the replacement presses on until seated.
• If the original knob used a set screw or retaining clip, save and reinstall that hardware.
• If the knob does not seat easily, stop and verify shaft type and fit to avoid damage.

This replacement thermostat knob mounts on the control shaft to set cooking temperature. It restores a secure grip and clear pointer so you can choose settings reliably when the original knob is cracked, stripped, or missing. What it does:

• Attaches to the thermostat/control shaft to adjust temperature settings
• Provides a clear pointer and tactile grip for accurate selection
• Can help resolve issues like slipping, not engaging the stem, or worn/illegible markings
• Helps restore consistent temperature adjustment when the original knob is damaged or missing

• One thermostat control knob

• Turn the appliance off and allow surfaces to cool before servicing
• Pull the old knob straight off the shaft—do not pry against the control panel
• Align the new knob with the shaft orientation/indicator and press on until fully seated
• Verify the pointer aligns with the Off/temperature marks and turns smoothly through the range

This seal strip replaces a worn or damaged door gasket edge to restore a proper seal and help the appliance maintain temperature and operate quietly. It's a direct-fit service part used where a continuous seal is required. What it does:

• Provides a flexible barrier along the door/frame to reduce air leaks and heat/cold loss
• Helps prevent moisture buildup and improves energy efficiency when sealing is restored
• Reduces rattling and vibration caused by a compressed or torn seal edge
• Commonly replaced when the strip is torn, missing, or no longer adheres properly

• One seal strip

• Disconnect power to the appliance before servicing to avoid electrical or burn hazards
• Clean and dry the mounting surface; remove old adhesive or residue for best adhesion
• Align the strip carefully and press firmly; allow any adhesive to cure per manufacturer instructions

This spacer maintains the correct gap between mating components inside your appliance, keeping parts aligned and operating smoothly. Replacing a worn or missing spacer restores proper fit and helps prevent rubbing, noise, and premature wear. What it does:

• Sets and preserves the correct stand-off between components for proper alignment
• Helps ensure smooth operation and consistent control feel
• Reduces friction and contact that can cause noise or wear
• Common failure signs: loose or wobbly parts, rubbing/scraping sounds, misalignment, poor fit

• 1 spacer

• Disconnect power and, if applicable, shut off gas supply before servicing.
• Note the orientation of the original spacer and match it during reassembly.
• Handle nearby trim and control components carefully to avoid damage.
• After reassembly, verify smooth operation and proper clearances before restoring power/gas.

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.