Parts for Maytag A107S: 03 - Bleach Injection System Parts

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.

Clamp Includes 205529 Bolt Kit. It Does *not* include The The Rubber Seal. If Seal Required, Use WP211232

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.

This hose clamp secures a rubber or plastic hose to its fitting to maintain a tight, leak-resistant seal. Replace a worn or missing clamp to stop drips and keep appliance water connections secure.

• Fastens a hose to a barb or port to prevent leaks
• Helps keep hoses from slipping off due to vibration or pressure
• Restores proper sealing when a clamp is rusted, bent, or stripped
• Common symptoms: water dripping at a hose joint, loose hose connection, or a clamp that won't tighten

• Disconnect power and shut off the water supply before servicing
• Place a towel to catch residual water when removing hoses
• Position the clamp just behind the hose barb/bead and secure with the appropriate tool
• Restore water and power, then run a quick check for leaks at the connection

This is a rubber gasket seal that fits between the outer tub halves or around the tub ring of a washing machine, creating a watertight seal to prevent leaks during the wash and spin cycles. It compresses between the tub components when they are clamped together. Replace this seal if you notice water leaking from around the outer tub, pooling under the washer, or if the seal appears cracked, hardened, or deformed.

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.

Small plastic ball component that snaps into washer lid hinge mechanism. Replace when missing, cracked, or broken to restore smooth lid opening and closing.

The hinged top cover of the washing machine that provides access to the wash basket. Replace when it won't stay closed, has cracks, or the safety switch mechanism is damaged preventing the washer from operating.

A flexible seal that prevents heat and moisture from escaping around oven doors or cooktop surfaces. Located along door edges or burner perimeters, replacement is necessary when you notice heat loss, visible cracks, or hardened rubber material.

This lid bumper cushions the contact point between a washer lid and the top panel to reduce slamming noise and protect the finish. Replacing a worn or missing bumper restores smooth, quiet lid operation and helps prevent paint damage.

• Provides a soft stop between the lid and top to minimize noise and vibration
• Helps prevent chips, scratches, and rust where the lid meets the cabinet
• Maintains proper lid spacing for a solid, rattle-free close
• Common signs it's needed: missing/flattened bumper, louder closing, rattling, or visible wear at contact points

• Disconnect power before servicing
• Open the lid, remove the old bumper, and clean the mounting area
• Seat the new bumper fully in the mounting location as designed
• Open/close the lid to ensure quiet, secure contact

This inlet fitting allows bleach to enter the washer's dispenser system and connects to the main water supply line. Replace when bleach doesn't dispense properly, leaks occur around the inlet, or the fitting becomes clogged or damaged.

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.