Parts for Frigidaire FDBB944CS2: 03 - Control Panel Parts

Removes residue, odor-causing soils, and food particles from dishwasher tub and gasket. Use monthly to eliminate unwanted odors and maintain peak performance.

White control panel touch pad insert for dishwashers. Replaces cracked, discolored, or worn touch pad overlays on the control panel interface.

Fix a dishwasher that won't advance past a certain cycle point or stops mid-wash. This electronic control board manages timing and cycle progression.

Removes residue, odor-causing soils, and food particles from dishwasher tub and gasket. Use monthly to eliminate unwanted odors and maintain peak performance.

This is a replacement energy guide label that restores the factory energy-use and efficiency information on the appliance. It provides a clear, adhesive-backed label that matches the original for identification and resale requirements. What it does:

• Displays the appliance's energy usage and efficiency information as shown on the original label.
• Replaces faded, torn or missing labels so energy information is legible for buyers and service techs.
• Helps maintain the appliance's original appearance where the label is required or expected.
• Fits where the factory energy guide was applied; adhesive backing provides a permanent attachment on smooth surfaces.

• Clean the surface thoroughly and remove any old adhesive or debris before applying.
• Peel backing and press label firmly in place, smoothing out air bubbles.
• Apply only to smooth, dry, non-porous surfaces for best adhesion.
• Do not use near high-heat areas or where label could obstruct vents or controls.

Mounting screw for dishwasher assembly. Secures internal components and panels. Replace if missing, stripped, or corroded during maintenance or repair.

6 - 10 x 3/8, pan plask, switch

This thermistor is the dishwasher's temperature sensor. It reports water temperature to the control so the heater and cycle timing are managed correctly, helping restore reliable wash performance and more consistent drying.

• Monitors water temperature in the tub/sump and sends readings to the control board
• Helps the control regulate heater operation and determine cycle progress/timing
• Failure can result in no heat or poor drying
• May cause unusually long/short cycles or temperature-related fault codes

• Disconnect power at the breaker and shut off the water supply before servicing
• Access is typically from the toe-kick/base area or sump; remove the lower access panel as needed
• Release the locking tab/clip, remove the sensor, and ensure the existing seal/O-ring is properly seated; install the new sensor fully to prevent leaks
• Reconnect the wire harness, restore power, and run a test cycle to check for leaks and proper heating

The Side Mount Kit is an OEM replacement part for Frigidaire dishwashers. It contains mounting brackets, screws, and other hardware required to securely install the dishwasher against cabinetry in a side-by-side configuration. Proper attachment is necessary for stability and safety during operation. 

Symptoms of damaged or missing mounting hardware include:

• Excessive movement or rocking of the dishwasher body
• Potential detachment from cabinets  
• Screws pulling loose from repeated vibrations
• Improper door alignment causing difficulty closing fully

Causes related to normal wear over extended use periods. Damage may occur if weight is applied during improper lifting or installation attempts.  

Compatible models include Electrolux, Gibson, and select Kenmore units.

Removes residue, odor-causing soils, and food particles from dishwasher tub and gasket. Use monthly to eliminate unwanted odors and maintain peak performance.