Parts for Maytag MDG4658AWW: 03 - Control Panel & Top Parts

This replacement screw secures panels, brackets, and internal components inside your appliance to keep them aligned and rattle-free. Replace stripped, rusty, or missing hardware to restore a tight fit and dependable operation.

• Holds metal panels, brackets, ducts, or trim in place
• Helps maintain alignment and reduces vibration and noise
• Replaces missing, corroded, or stripped screws
• Common symptoms: loose panel or component, rattling/buzzing during use, screw won't tighten

• Disconnect power and shut off gas/water before servicing
• Start threads by hand to avoid cross-threading; use the correct driver
• Replace one fastener at a time to maintain alignment
• Tighten snugly—do not overtighten to prevent stripping

Backguard shield cap for dryers. Covers and protects the rear panel components. Replace if cracked, broken, or missing to restore proper appearance.

This 4-position rotary encoder is the user-control input that lets the appliance detect selector knob positions so settings change reliably. It replaces a worn or faulty encoder to restore responsive cycle selection. What it does

• Converts knob rotation into electrical signals so the control board reads selected settings
• Replaces an encoder that causes intermittent or no response when turning the selector
• Helps stop erratic or incorrect cycle selection caused by a worn or damaged shaft or contacts
• Resolves clicking, jumpy, or unregistered position changes at the console

• One rotary encoder (4-position) as pictured

• Disconnect power to the appliance before starting any repair
• Access usually requires removing the control panel or console; keep track of screws and fasteners
• Handle the encoder and circuit board carefully to avoid ESD or mechanical damage
• Test selector operation after reinstalling the panel and restoring power

Dryer shuts off after 15-30 seconds? Flickering lights or unresponsive controls? This electronic control board restores normal cycle operation.

Replace a cracked, broken, or missing control panel selector knob. Installs on the control shaft to restore cycle and setting selection functionality.

Felt pad installs under the drum glide to prevent metal-on-metal contact and reduce friction. Replace if worn, causing grinding noise or squealing.

Color: White