Parts for Maytag MDG5806AWK: 03 - Control Panel & Top Parts

This replacement screw secures panels, brackets, and internal components inside your appliance to keep them aligned and rattle-free. Replace stripped, rusty, or missing hardware to restore a tight fit and dependable operation.

• Holds metal panels, brackets, ducts, or trim in place
• Helps maintain alignment and reduces vibration and noise
• Replaces missing, corroded, or stripped screws
• Common symptoms: loose panel or component, rattling/buzzing during use, screw won't tighten

• Disconnect power and shut off gas/water before servicing
• Start threads by hand to avoid cross-threading; use the correct driver
• Replace one fastener at a time to maintain alignment
• Tighten snugly—do not overtighten to prevent stripping

Backguard shield cap for dryers. Covers and protects the rear panel components. Replace if cracked, broken, or missing to restore proper appearance.

This 4-position rotary encoder is the user-control input that lets the appliance detect selector knob positions so settings change reliably. It replaces a worn or faulty encoder to restore responsive cycle selection. What it does

• Converts knob rotation into electrical signals so the control board reads selected settings
• Replaces an encoder that causes intermittent or no response when turning the selector
• Helps stop erratic or incorrect cycle selection caused by a worn or damaged shaft or contacts
• Resolves clicking, jumpy, or unregistered position changes at the console

• One rotary encoder (4-position) as pictured

• Disconnect power to the appliance before starting any repair
• Access usually requires removing the control panel or console; keep track of screws and fasteners
• Handle the encoder and circuit board carefully to avoid ESD or mechanical damage
• Test selector operation after reinstalling the panel and restoring power

Dryer shuts off after 15-30 seconds? Flickering lights or unresponsive controls? This electronic control board restores normal cycle operation.

This right-side blue end cap finishes and protects the trim on your appliance door, restoring a clean look and preventing exposed edges. It's a simple cosmetic/replacement part that helps maintain a proper seal and appearance. What it does:

• Covers and protects the outer edge of the door trim on the right side
• Prevents sharp or exposed trim edges that can catch or wear
• Restores finished appearance after a cracked, faded, or missing cap
• Helps keep the trim aligned so gaskets and seals fit as intended

• Disconnect power to the appliance before starting work
• Typically snaps or slides into place from the door edge; may require removing adjacent trim first
• Use gentle pressure to avoid cracking plastic; if the cap is stubborn, a trim removal tool can help

Color: gray. The back part of the knob measures about an inch in diameter, and the front part with the handle is about 2 inches in diameter.

Felt pad installs under the drum glide to prevent metal-on-metal contact and reduce friction. Replace if worn, causing grinding noise or squealing.