Parts for Maytag RTD2300AAL / CH93B: 03 - Inner Door Parts

This part has been discontinued by the manufacturer and is no longer available.

Replacement mounting screw for securing freezer panels, brackets, and components. Restores proper fastening where original screw is missing, stripped, or damaged.

This support bar holds refrigerator shelves securely in place and prevents them from sliding out accidentally. It attaches to the shelf's front edge and provides structural stability. Replace if shelves slide out too easily, sag in the middle, or the retainer bar is cracked or broken.

This refrigerator bottom shelf endcap closes off the end of wire shelving to prevent items from sliding off. It provides a finished appearance while keeping food containers and bottles securely positioned on the shelf. Replace this endcap if it's cracked, missing, or no longer holds items securely on the shelf edge.

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.

Right Side

This is a left-side shelf hook that snaps into the refrigerator door liner to support a door shelf or bin. It acts as a bracket or pick-off point that holds the shelf securely in place. Replace this hook if a door shelf is sagging, tilting, or falling off because the support clip is broken or missing.

This factory rivet is used to permanently fasten appliance panels and hardware. Replacing a worn or missing rivet restores a tight, rattle-free fit and keeps panels, brackets, or trim aligned as designed. What it does:

• Permanently secures sheet-metal or plastic parts where a rivet was originally installed
• Helps maintain alignment and rigidity; reduces vibration and rattling
• Replace if the original rivet is missing, loose, corroded, or drilled out during service
• Common symptoms include loose panel/trim pieces, buzzing noises, or visible gaps

• 1 rivet

• Disconnect power and shut off gas/water before servicing
• Remove the old rivet by carefully drilling through the rivet head; support nearby parts to prevent damage
• Install the new rivet with a suitable rivet tool; it seats fully and securely
• Wear eye protection when drilling or riveting; rivets are single-use and should not be reused