Parts for Electrolux FDSP4401AS1A: 04 - Electrical Parts

Dissolves limescale, mineral deposits, and odor-causing residues from dishwasher tub and spray system. Use monthly to maintain peak cleaning performance.

Dishwasher not filling with water or showing i20 error? The water inlet valve controls water flow into your dishwasher. DIY repair in under an hour.

Fix a dishwasher that won't drain or leaves standing water with this drain pump assembly. Direct replacement restores proper drainage and cycle completion.

Fixes dishwasher leaking, error code i20, or pump that won't stop running. Monitors water pressure to control wash cycles. DIY-friendly repair.

Replacement sensor assembly that detects appliance operating conditions and sends readings to the control system for proper operation. Installing a working sensor restores reliable feedback and helps resolve related error codes or inconsistent performance. What it does:

• Detects operating conditions and provides electrical feedback to the appliance control.
• Enables the control board to monitor and adjust cycles based on measured readings.
• Faulty or intermittent sensors can cause incorrect readings, error codes, or unstable/incorrect appliance operation.
• Replacing a failed sensor restores accurate sensing and helps return the appliance to normal function.

• Always disconnect power to the appliance before starting work to avoid shock or injury.
• Handle the sensor and wiring gently; avoid pulling on wires or bending sensor probes sharply.
• Ensure connectors are fully seated and routed clear of moving parts or heat sources.
• After installation, restore power and verify proper operation and that any previous error codes are cleared.

Fix a soap door that won't open or stay closed. This detergent dispenser releases soap at the right time during wash cycles. DIY-friendly repair.

If your dishwasher won't start or stops mid-cycle, a faulty door lock may be the cause. This safety component secures the door during wash cycles.

Fix poor drying or excess moisture with this dishwasher blower assembly. Direct replacement for circulation issues. Moderate DIY repair, 1-2 hours.

Dissolves limescale, mineral deposits, and odor-causing residues from dishwasher tub and spray system. Use monthly to maintain peak cleaning performance.

This switch assembly restores electrical on/off control for a specific appliance function. Replace a worn or failed switch to stop intermittent operation and return reliable control to the affected circuit. What it does:

• Provides the electrical on/off or function control for the appliance circuit.
• Replaces a failed switch that can cause intermittent operation or unresponsive controls.
• Helps resolve symptoms such as a function that won't start, no response from the control, or erratic switching.
• Connects to the existing wiring harness and mates with the original mounting points.

• Disconnect power to the appliance before beginning any work.
• Remove the appropriate access panel to reach the switch; note wire and terminal locations before disconnecting.
• Unplug the wiring harness or carefully detach terminals, swap the switch assembly, then reconnect securely.
• Restore power and verify the replaced switch operates the function correctly.

Dishwasher won't drain or leaves water in the tub? This drain pump wiring harness restores electrical connection to the pump for reliable draining.

Dishwasher won't power on or has intermittent electrical issues? The main wiring harness connects control and power circuits. Moderate DIY repair.

Dissolves limescale, mineral deposits, and odor-causing residues from dishwasher tub and spray system. Use monthly to maintain peak cleaning performance.