Parts for Maytag RTF1900CAE: 04 - Inner Door Parts

This is a replacement mounting screw for securing appliance components and panels. It restores proper fastening where a missing or stripped screw causes loose parts or rattling. What it does:

• Fastens panels, brackets, or small components to restore secure attachment
• Prevents vibration and rattling caused by loose or missing fasteners
• Replaces stripped or lost factory screws to maintain original fit
• Matches OEM fit for the specific mounting location when the part number is specified

• Use the matching screw location and size specified by the parts diagram
• Hand-start threads to avoid cross-threading; tighten securely but do not overtighten
• Disconnect power to the appliance before removing panels or components
• If threads are damaged, replace with correct OEM screw—do not force a mismatched fastener

This door bar shelf support end cap can be used on both the right and left hand on many Maytag refrigerator and freezer doors. Color: white. Measures about 1-1/2 inches high by 3 inches deep.

Refrigerator door shelf support. Color: White. Measures about 2 inches high by 3 inches deep. For brown order 67208-1.

Color: white. Measures about 3 inches high by 2 inches deep.

Shelf snugger used to keep shelf contents from sliding around. This part has been discontinued and is no longer available.

Right Side

Left Side

This factory rivet is used to permanently fasten appliance panels and hardware. Replacing a worn or missing rivet restores a tight, rattle-free fit and keeps panels, brackets, or trim aligned as designed. What it does:

• Permanently secures sheet-metal or plastic parts where a rivet was originally installed
• Helps maintain alignment and rigidity; reduces vibration and rattling
• Replace if the original rivet is missing, loose, corroded, or drilled out during service
• Common symptoms include loose panel/trim pieces, buzzing noises, or visible gaps

• 1 rivet

• Disconnect power and shut off gas/water before servicing
• Remove the old rivet by carefully drilling through the rivet head; support nearby parts to prevent damage
• Install the new rivet with a suitable rivet tool; it seats fully and securely
• Wear eye protection when drilling or riveting; rivets are single-use and should not be reused