Parts for Electrolux PCFD3670AFA: 04 - Main Top Parts

Pilot won't stay lit or oven won't heat? This thermocouple senses the flame and signals the gas valve to stay open. Easy DIY repair in under an hour.

Replacement door stop bumper for gas ranges. Cushions door closure, prevents hard impact between door and cabinet. Replace if cracked, worn, or missing.

This thermostat is the temperature control device that regulates cooling cycles to keep the appliance at the set temperature. It restores consistent temperature control for reliable food preservation when the original control fails. What it does:

• Senses cabinet temperature and opens/closes the control circuit to start or stop the compressor
• Helps maintain set temperature by cycling the cooling system on and off
• Commonly replaced when the appliance runs too warm, too cold, or won't maintain temperature
• Can stop excessive compressor run time or prevent the compressor from running at all

• Disconnect power to the appliance before removing or installing the thermostat
• Note or photograph original wiring and mounting location for correct reinstallation
• Test the thermostat with a multimeter for continuity before replacing

This cooktop grate replaces a damaged or missing burner grate to safely support cookware and restore stable cooking on a gas range. It helps keep pots and pans level so burners heat cookware as intended. What it does:

• Supports cookware above the burner so pots and pans sit securely
• Centers cookware for proper flame contact and consistent heating
• Replaces cracked, broken, warped, or missing grates that cause wobbling
• Restores a finished look to the cooktop and prevents direct contact with burner caps

• Remove cookware and let the cooktop cool completely before handling
• Lift out the old grate and set the replacement into position; no special tools typically required
• Handle with care—grates can be heavy or have sharp edges
• Follow the range manufacturer's safety and maintenance instructions

Protective push-on cap covers exposed fasteners on gas ranges and cooktops. Replace if cracked, missing, or loose to prevent dirt and moisture damage. Verify fit with your model number.

Fixes burners that won't light or spark continuously. This ignition control module sends high-voltage sparks to surface burner electrodes for reliable gas ignition.

Replaces cracked, dented, or scratched decorative outer trim on gas ranges. Restores finished appearance and covers panel edges for a clean look.

Trim assembly for gas cooktops. Installs around burners to create a finished edge. Replace if cracked, chipped, discolored, or missing pieces affect appearance.

Burner cap for gas cooktop. Sits on top of burner head to distribute flame evenly. Replace if cracked, chipped, discolored, or missing. Easy install.