Parts for Bosch SECD302BB01: 06 Upper Oven Convection Parts

Mounting bracket that secures the convection motor inside your oven cavity. Replace if cracked, bent, or missing to properly support the motor assembly.

This is the upper broil element located at the top of the oven cavity, responsible for producing high, direct heat for broiling food. It is a looped metal heating element that glows red when energized. Replace this element if it no longer heats up, heats unevenly, has visible cracks or blistering, or if the broil function stops working entirely.

Restore even baking when your oven heats unevenly. This convection fan blade circulates hot air for consistent cooking. Moderate DIY install.

Replacement mounting nut for securing internal oven and range components. Needed when original fastener is stripped, missing, or damaged during repair work.

Oven lamp assembly provides interior lighting for viewing food during cooking. Replace when bulb burns out or housing cracks. Verify fit with your model.

Fix intermittent power or component failure with this range socket electrical connector. Restores secure wiring connections in electric and gas ranges.

A replacement temperature sensor (thermistor) that monitors internal temperatures and sends readings to the appliance control board. Restores accurate temperature sensing to help cycles and temperature regulation run correctly. What it does:

• Measures internal temperature and relays readings to the control board so the appliance can adjust heating/cooling cycles.
• Helps ensure proper defrost or cycle timing by providing accurate temperature feedback.
• Common symptoms of a failing sensor: inconsistent temperatures, frequent or short cycling, or temperature-related performance issues.
• Works as a direct replacement for a worn or failed sensor to restore normal temperature monitoring.

• Disconnect power to the appliance before starting any repair to avoid shock or damage.
• Handle the sensor and wiring gently; avoid kinking or pulling the lead and ensure the connector seats fully.
• Installation typically requires access behind panels or inside the compartment—keep fasteners organized and follow the service manual.

Oven not heating evenly in convection mode? This rear convection heating element restores proper temperature. DIY-friendly, typically installs in 10-20 minutes.

This meat probe sensor is a temperature-sensing device that inserts into food while it cooks in the oven, allowing the oven to monitor the internal temperature and automatically stop cooking when the target temperature is reached. It connects to a jack inside the oven cavity via a heat-resistant cable. Replace this probe if your oven no longer reads the food temperature accurately, displays a probe error code, or if the cable or tip is visibly damaged.

The Bulb is an OEM part for Bosch ovens. This component provides illumination inside the oven, allowing you to easily monitor the cooking process without opening the door and losing heat.

Causes of a bad bulb can include filament burnout due to extended use, electrical issues that cause power surges, or physical damage from accidental impacts. 

Symptoms of a bad bulb include:

• The oven light not turning on
• Flickering light inside the oven
• Dim or uneven lighting
• The bulb appearing visibly damaged or burnt out

This OEM Bosch part is also compatible with Thermador, Gaggenau, and some Kenmore models.