Parts for Thermador PRDS366: 09 - Frame Parts

The range leveling leg is an adjustable support foot located at each corner of the range that ensures the appliance sits level and stable. Replace when the leg is damaged, won't adjust properly, or the range rocks or tilts despite adjustment attempts.

Anti-tip bracket kit designed to secure your range to the wall or floor. Replaces broken, missing, or damaged brackets to prevent tipping hazards.

Relay terminal box housing for electric ranges. Encloses and protects electrical relay terminals. Replace if cracked, broken, or missing to restore coverage.

This door seal creates a watertight barrier between the dishwasher door and tub to contain wash water and steam. Replace a worn gasket to stop drips from the door area and restore a reliable, quiet seal.

• Seals the perimeter of the door to help prevent leaks at the sides and top
• Helps the door close snugly and contain moisture/steam
• Replaces seals that are cracked, flattened, deformed, or shedding pieces
• Typical symptoms: water on the floor near the door, dampness around the door frame, visible wear, door harder to close

• Disconnect power and turn off water supply before servicing
• Pull the old seal straight out; clean the groove/channel of residue and debris
• Warm the new seal to relax it; start at the top center and press it fully into the groove, ensuring corners are evenly seated
• Close the door for several hours to help the seal set, then run a short test cycle and check for leaks

Oven won't heat or element burned out? This high-temperature cut-out fuse interrupts power when temperatures exceed safe levels. Often fails with elements.

Support, hinge counter restores proper hinge support and door balance for a worn or damaged hinge assembly. This replacement helps the appliance door open and close smoothly and stay aligned for reliable everyday use. What it does:

• Provides structural support to the door hinge and helps counterbalance the door
• Stabilizes hinge movement to reduce sagging, binding, or uneven closing
• Helps the door latch and seal correctly by keeping the hinge alignment consistent
• Use when you notice door droop, difficulty latching, or irregular door motion

• Installation may require partial disassembly of the door or hinge assembly—refer to the OEM instructions for your model
• Disconnect power and turn off water supply before beginning any repair
• Inspect surrounding hinge components and fasteners; replace any damaged parts and test door operation after installation

Replace a cracked, broken, or missing latch cover plate on your electric range. This housing cover installs over the door latch mechanism for a complete finish.