Parts for Thermador PRDS366: 18 - Control Panel Parts

Wire harness assembly that connects electrical components in your range. Replace if wires are frayed, damaged, or connector pins are corroded or broken.

This left side trim piece replaces a damaged or missing side trim to restore the cabinet edge and finished appearance of the appliance. It helps maintain a flush fit and clean look along the refrigerator side. What it does:

• Covers and protects the exposed edge of the cabinet for a finished appearance
• Restores proper trim alignment to reduce gaps and rubbing against adjacent surfaces
• Replaces cracked, dented or missing trim that detracts from the appliance finish
• Helps maintain a uniform seal and appearance after service or collision repair

• Always unplug the appliance or turn off power before starting cosmetic or trim repairs
• Installation typically involves removing any adjacent molding or fasteners and snapping or fastening the trim into place; keep original fasteners if reusing
• Handle edges carefully to avoid cuts or damaging adjacent panels

This right side trim is a molded exterior trim piece that restores the appliance's finished look and covers the cabinet edge. It keeps the side of the unit looking clean and replaces damaged or missing trim for a factory appearance. What it does:

• Replaces a cracked, chipped, or missing right-side exterior trim piece
• Covers and protects the cabinet edge from scrapes and dirt
• Restores the original appearance for a seamless door/cabinet fit
• Helps prevent gaps that can collect debris around the appliance edge

• Remove power and empty surrounding area for safe access before starting
• Typical install uses existing clips or screws—retain original fasteners when possible
• Handle trim carefully to avoid scratching the finish during installation
• If trim does not align, inspect mounting clips for damage

Control panel trim for 36-inch electric ranges. Replaces damaged, cracked, or discolored trim pieces around the range control panel interface.

This is a structural frame that surrounds and supports the oven door, providing rigidity and a finished appearance. It holds the door glass and inner panel components securely in place. Replace this frame if it is bent, cracked, or damaged, which can cause the door to fit poorly, allow heat to escape, or create an uneven seal against the oven opening.

This pilot light lens covers and diffuses the control-panel indicator lamp. Replace a cracked, missing, or discolored lens to restore clear visibility of the light, protect the lamp opening, and keep the panel looking finished.

• Covers and diffuses the indicator lamp on the control panel
• Helps protect the lamp opening from debris and accidental contact
• Restores a clean, finished appearance to the panel
• Replace if the lens is cracked, missing, loose, or discolored
• Can help when the indicator is hard to see even when lit

• Disconnect power to the appliance before servicing and allow surfaces to cool
• Access the indicator opening from the front or rear (varies by design) and remove any retainer or clips holding the old lens
• Note orientation and transfer any existing retainer or gasket if present
• Seat the new lens fully, reassemble, and test the indicator light

If your range burner won't heat properly or stays on continuously, the infinite switch may need replacement. This control regulates heat levels.

This part has been discontinued and is no longer available