Parts for Thermador CEH456QB: 11 - Control Panel Parts

This standoff is a small spacer used to secure and separate panels or circuit boards, keeping components aligned and preventing electrical contact. It restores proper spacing for stable assembly and reduces vibration-related issues. What it does:

• Creates a fixed gap between a PCB or panel and the mounting surface to prevent shorts
• Holds boards/panels securely to stop movement and reduce noise from vibration
• Maintains correct alignment for connectors and fasteners
• Helps prevent rubbing or chafing that can cause wear or intermittent connections

• Disconnect power and unplug the appliance before replacing any internal parts
• Handle circuit boards and connectors by the edges to avoid static or physical damage
• Use the correct screw length and thread; do not overtighten the standoff to avoid cracking

This replacement relay switches high-voltage circuits in the appliance, restoring reliable on/off control for the powered component. It's a direct-fit electrical relay used where a single normally-open contact is required. What it does:

• Acts as a voltage-controlled switch to open or close the 208–240V circuit
• Re-establishes power to components that fail to energize due to a faulty relay
• Commonly replaces relays that click continuously, fail to make contact, or leave a circuit permanently open
• Rated for 10 amps on a single normally-open contact for mid-load switching

• One relay (208–240V, 10A, 1 N.O.)

• Disconnect all power to the appliance before inspecting or replacing the relay
• Verify wire locations and harness orientation before removing the old relay; take photos if needed
• Use proper tools and avoid bending terminals; replace with the exact relay specified for your appliance