Parts for Thermador PRSE304S: 12 - Control Panel Parts

This part has been discontinued and is no longer available

Replace your range's bottom kick panel if cracked, damaged, or missing. This trim piece covers the base area beneath the oven door for a finished look.

Replace your range's 30-inch oven door handle when the existing handle is cracked, broken, or worn. Includes endcaps for complete installation.

This part has been discontinued by the manufacturer and is no longer available.

Oven door won't close or stay shut? This door strike latch engages the catch to keep your oven door secure. Simple fix for worn latches.

This 65-inch door gasket seals your range door to maintain proper temperature and prevent heat loss. Replace when worn, torn, or no longer sealing tightly.

Replace worn door bottom insulation to improve heat retention and energy efficiency. Prevents heat loss during cooking. Verify fit with your range model number.

Replaces the interior glass pane in your oven door assembly. Needed when the original inner glass is cracked, shattered, or broken. Restores visibility.

Replace your oven door glass spacer if it's cracked, broken, or missing. This spacer sits between glass panels in range oven doors for proper alignment.

This is a broiler pan designed to sit inside the oven compartment for broiling meats, vegetables, and other foods. It catches grease and drippings while allowing heat to circulate around the food for even cooking. Replace this pan if it is warped, heavily corroded, has burned-through spots, or can no longer be cleaned effectively.

This pilot light lens covers and diffuses the control-panel indicator lamp. Replace a cracked, missing, or discolored lens to restore clear visibility of the light, protect the lamp opening, and keep the panel looking finished.

• Covers and diffuses the indicator lamp on the control panel
• Helps protect the lamp opening from debris and accidental contact
• Restores a clean, finished appearance to the panel
• Replace if the lens is cracked, missing, loose, or discolored
• Can help when the indicator is hard to see even when lit

• Disconnect power to the appliance before servicing and allow surfaces to cool
• Access the indicator opening from the front or rear (varies by design) and remove any retainer or clips holding the old lens
• Note orientation and transfer any existing retainer or gasket if present
• Seat the new lens fully, reassemble, and test the indicator light