Parts for Thermador GPS366S: 12 - Fasteners Parts

This is a 1/4-20 hex keps nut — a hex nut with an attached captive washer that helps secure panels, brackets, and fasteners. It provides a simple, vibration-resistant fastening solution for appliance assemblies. What it does

• Fastens components to machine frames, panels, and brackets using a 1/4-20 bolt or stud.
• Captive washer helps resist loosening from vibration and movement.
• Commonly used where a compact, pre-assembled nut-and-washer is needed for reliable retention.
• Replace when threads are stripped, washer is damaged, or parts wobble or rattle.

• One hex keps nut (1/4-20).

• Disconnect power and follow appliance safety procedures before working on hardware.
• Use the correct 1/4" socket or wrench to install; hold the mating bolt head as needed to tighten.
• Tighten securely but avoid over-tightening to prevent thread damage or distortion.
• Replace with the same nut type and size to maintain fit and vibration resistance.

This Tinnerman C nut is a spring-steel speed clip that secures sheet-metal panels and components using a mating screw. It provides a captive thread where a tapped hole or weld nut isn't practical, helping restore proper fit and stop rattles. What it does:

• Provides a captive, reusable threaded anchor for self-tapping or machine screws
• Secures trim, access panels and internal brackets to sheet-metal edges or panels
• Stops panel movement and vibration-related noise when the original clip is damaged or missing
• Works where a conventional nut or stud cannot be used due to limited access

• Disconnect power and unplug the appliance before accessing panels or fasteners
• Position the clip over the panel edge or hole, then press or slide until it snaps into place
• Align the mating screw and thread carefully to avoid cross-threading the clip
• Use hand tools or pliers for placement; do not over-torque the screw once installed

This 1/2-inch foam adhesive tape cushions and seals appliance gaps to reduce vibration and prevent rubbing or rattling of panels. It's a simple, flexible trim that restores fit and quiets noisy or loose parts. What it does:

• Provides a soft, compressible barrier to reduce panel-to-panel contact and eliminate rattles
• Helps seal small gaps to keep out dust and reduce drafts around doors or trim
• Cushions components to damp vibration and protect finishes from wear
• Conforms to irregular surfaces for easy placement in tight spots

• Access the area with the appliance powered off and, if applicable, unplugged for safety
• Clean and dry the surface before applying for best adhesion
• Cut to fit with scissors or a utility knife and press firmly to set the adhesive
• Replace if the foam is compressed, torn, or no longer adheres

Package of 60 pyramid shaped briquettes