Parts for Thermador CM302B: 16 - Upper Microwave Door Parts

This is a replacement door gasket that restores a tight seal around the appliance door to help prevent leaks and reduce energy loss. Designed to match the OEM fit and form for reliable sealing performance. What it does

• Creates a full door seal to help keep water, steam, heat, and cold where they belong.
• Helps stop common leak symptoms such as water pooling or dripping from the door.
• Can reduce energy loss and cycling caused by a worn or damaged seal.
• Visible wear, tears, compression, or gaps are common signs the gasket needs replacing.

• Disconnect power and, if applicable, water supply before beginning any service.
• Remove the door panel or trim only if required by your model; follow manufacturer instructions.
• Clean the gasket channel and seating surface before installing the new gasket for best fit.
• Press the gasket into the channel evenly; avoid stretching or pinching the seal during installation.

This inner door glass is the replacement glass panel that fits inside the appliance door and restores a clear, intact viewing surface. Replacing a damaged inner glass helps maintain door integrity and normal operation. What it does:

• Replaces cracked, chipped, or broken inner door glass to restore a safe viewing window
• Prevents loose glass shards and helps the door close and seal properly
• Restores a clean, clear view into the appliance cavity without affecting exterior trim
• Matches the OEM inner glass design for proper fit and alignment

• 1 inner door glass panel

• Recommended for experienced DIYers; handle glass carefully to avoid cuts
• Remove power and follow manufacturer door-disassembly steps before replacing the inner glass
• Use appropriate fasteners and gaskets from the original assembly; do not force-fit the glass
• Inspect surrounding door parts (brackets, clips, seals) and replace any damaged pieces to ensure proper reassembly

A glass spacer used to position and support the cooktop glass where it mounts to the frame. Restores proper spacing and alignment for a secure, even fit on compatible Bosch cooktops. What it does:

• Keeps the cooktop glass properly spaced from the mounting frame to prevent rubbing or uneven gaps
• Helps maintain a stable, even surface for burners and cookware
• Reduces stress on the glass by providing an intended support point
• Can address symptoms like a misaligned or wobbly glass top and uneven gaps around the edge

• Intended for the specified cooktop mounting location; verify exact placement before installing
• Turn off power to the appliance and allow all surfaces to cool completely before service
• Handle glass parts carefully and use appropriate gloves to avoid cuts

This left-side door end cap replaces the damaged or worn trim piece at the edge of the appliance door, restoring a finished appearance and helping keep the door seal and adjacent trim aligned. Fits the factory left-hand end position and matches original black finish. What it does:

• Covers and protects the outer edge of the door where the hinge/trim meets the panel
• Restores finished look and helps prevent dirt or moisture intrusion at the door edge
• Replaces cracked, broken or missing left-side end cap that can snag or catch
• Matches the original part shape and mounting points for a direct fit

• Intended for left-side door end position only; confirm left/right before ordering
• Basic trim removal and reinstallation required; keep fasteners and clips for reuse if possible
• Power off and unplug the appliance before performing any door repairs to avoid injury
• Inspect adjacent trim and fasteners during install; replace any damaged clips for secure fit

This door strike is the small metal latch that engages the door catch so the appliance door closes and stays secure. Replaces a worn or damaged strike to restore proper door latching and safe operation. What it does:

• Provides the mating latch surface for the door catch so the door stays closed
• Restores secure door closure when a worn or bent strike prevents latching
• Can help resolve symptoms such as a door that won't stay closed, won't latch, or prevents the unit from starting
• Black oxide finish resists corrosion and reduces visible wear

• One door strike (black oxide)

• Disconnect power (and water for dishwashers) before beginning any repair
• Remove door panel or access trim to reach the strike; keep screws and fasteners organized
• Align strike carefully with the door catch; tighten screws snugly but avoid over-torquing
• Test door operation and any door-interlock switches before reassembling the unit