Parts for Thermador PCS484GD: 22 - Control Panel Parts

48-inch welded backguard top assembly for professional cooktops. Replace this rear trim panel when cracked, damaged, or discolored from heat exposure.

Rear backguard panel for cooktop. Replaces cracked, damaged, or missing rear trim panel. Mounts along the back edge to complete the cooktop appearance.

This part has been discontinued by the manufacturer and is no longer available.

Right side counter trim panel for 48-inch cooktops. Replaces cracked, chipped, or missing trim pieces. Installs along the counter edge for a finished look.

This side-trim gasket seals the edge of the appliance door/trim to help maintain a clean fit and reduce rattling or light air leakage. It restores the door edge seal for a neater appearance and improved closing performance. What it does:

• Seals the door side trim to help reduce noise and prevent light air or moisture intrusion
• Helps maintain proper alignment and fit of the door trim for smooth opening and closing
• Replaces worn, torn or compressed trim gasket that can cause rubbing or gaps
• Supports overall door aesthetics by restoring a continuous seal line

• One side-trim gasket

• Basic trim removal may be required
• Inspect mating surfaces and remove old adhesive or debris before installing the new gasket
• Use gentle pressure to seat the gasket; avoid stretching or over-tensioning
• Disconnect power to the appliance before doing any service that exposes electrical components

Decorative bullnose trim piece for cooktop edges. Installs along the perimeter for a finished look. Replace if cracked, chipped, discolored, or missing.

This pilot light lens covers and diffuses the control-panel indicator lamp. Replace a cracked, missing, or discolored lens to restore clear visibility of the light, protect the lamp opening, and keep the panel looking finished.

• Covers and diffuses the indicator lamp on the control panel
• Helps protect the lamp opening from debris and accidental contact
• Restores a clean, finished appearance to the panel
• Replace if the lens is cracked, missing, loose, or discolored
• Can help when the indicator is hard to see even when lit

• Disconnect power to the appliance before servicing and allow surfaces to cool
• Access the indicator opening from the front or rear (varies by design) and remove any retainer or clips holding the old lens
• Note orientation and transfer any existing retainer or gasket if present
• Seat the new lens fully, reassemble, and test the indicator light

Replacement grease tray cover for ranges and cooktops. Covers the grease collection area to contain drips and spills. Needed when original is cracked or missing.

Installation manual for gas cooktops. Provides step-by-step instructions for proper setup and configuration. Replacement for lost or damaged manuals.