Parts for Thermador PRG366US: 34 - Control Panel & Door Parts

The range indicator light with lens illuminates to show when a burner or oven is active, typically located on the control panel. Replace when the light fails to turn on, stays on constantly, or if the lens is cracked or discolored.

This pilot light lens covers and diffuses the control-panel indicator lamp. Replace a cracked, missing, or discolored lens to restore clear visibility of the light, protect the lamp opening, and keep the panel looking finished.

• Covers and diffuses the indicator lamp on the control panel
• Helps protect the lamp opening from debris and accidental contact
• Restores a clean, finished appearance to the panel
• Replace if the lens is cracked, missing, loose, or discolored
• Can help when the indicator is hard to see even when lit

• Disconnect power to the appliance before servicing and allow surfaces to cool
• Access the indicator opening from the front or rear (varies by design) and remove any retainer or clips holding the old lens
• Note orientation and transfer any existing retainer or gasket if present
• Seat the new lens fully, reassemble, and test the indicator light

If your range burner won't heat properly or stays on continuously, the infinite switch may need replacement. This control regulates heat levels.

Welded bullnose trim assembly for gas ranges. Installs on the front edge of the cooktop. Replace if cracked, chipped, or discolored to restore appearance.

Decorative trim piece that frames the control panel on your gas range. Replace if the original is cracked, chipped, discolored, or missing for a clean finish.

Decorative trim piece that frames the control panel on your gas range. Replace if the original is cracked, chipped, discolored, or missing for a clean finish.

Left-side hinge bracket for range oven doors. Secures the door hinge to the frame. Replace if cracked, bent, or if door alignment is compromised.

Left-side hinge bracket for range oven doors. Secures the door hinge to the frame. Replace if cracked, bent, or if door alignment is compromised.

Replace your oven door glass spacer if it's cracked, broken, or missing. This spacer sits between glass panels in range oven doors for proper alignment.

Replaces the interior glass pane in your oven door assembly. Needed when the original inner glass is cracked, shattered, or broken. Restores visibility.

Replaces the interior glass pane in your oven door assembly. Needed when the original inner glass is cracked, shattered, or broken. Restores visibility.

Replace your gas range's front handle assembly. Installs on the oven door or control panel. Order a new handle if yours is cracked, broken, or missing.

This right-side front frame piece replaces a damaged or worn exterior support on the appliance front. It restores proper panel alignment and helps maintain a flush fit and reliable door/panel operation. What it does

• Replaces the right front side frame that supports the appliance's front panel and trim
• Restores proper alignment to reduce gaps, rubbing or uneven panel fit
• Helps eliminate rattling or vibration caused by a broken or bent frame section
• Prevents further wear to adjoining panels and fastening points when intact

• Disconnect power to the appliance before starting any repair
• Basic hand tools (screwdriver, nut driver) may be required; keep fasteners for reuse
• Handle edges carefully—metal parts can be sharp

Replace your worn, scratched, or damaged 36-inch range door panel. This outer door trim installs on the front to restore your range's appearance.

Sound dampening insulation for gas ranges. Installs inside cabinet to reduce noise and provide thermal protection. Replace if torn, compressed, or missing.