Alliance Washer Parts

Fix a washer that won't advance cycles or drain properly. This timer controls wash sequences and cycle progression. Common DIY repair for stuck cycles.

White timer knob for washers. Mounts on the timer shaft to replace a cracked, broken, or missing knob. Restores your ability to select and adjust cycles.

Cosmetic bezel ring that mounts behind the timer knob on your washer control panel. Replace if cracked, broken, or missing to secure the knob properly.

Fix a washer that won't start or respond to controls with this switch assembly. Restores electrical switching in control and safety circuits.

Washer won't drain or leaves standing water after cycles? This drain pump removes water from the tub. Common repair that restores proper drainage.

Replacement timer knob assembly for dryers and washing machines. Restores control when original knob is cracked, broken, or worn. Installs on control panel.

Trunnion shaft kit for laundry center washers. Replaces worn, damaged, or broken trunnion shaft assembly. Essential structural component for drum support.

This replacement knob assembly with skirt restores a secure, easy-to-turn control interface on the appliance. It provides a finished look while allowing reliable selection of settings. What it does:

• Replaces a cracked, stripped, or missing control knob to restore user control
• Provides a stable grip and tactile feedback when turning settings
• Helps prevent accidental slips or selector misalignment caused by worn knobs
• Matches the original mounting style for a direct-fit replacement

• Disconnect power (unplug or switch off breaker) before starting any repair
• Remove the old knob by pulling straight off the control shaft; install the new knob by aligning and pushing fully onto the shaft
• If the original used a retaining clip or set screw, verify and reinstall it; only use parts explicitly included

Drive belt transfers motor power to spin the washer drum. Replace if agitation or spinning is weak, noisy, or fails. Verify fit by model number.

Lubricates washer seals, gaskets, and rubber parts to reduce noise and wear. Apply when parts become stiff or noisy. Verify fit with your model number.

Fix washer not filling, low water errors, or intermittent fill issues. This pressure sensor monitors water levels and signals the control board. DIY-friendly.