Replace aging or leaking washer supply lines with this fill hose kit. It provides two 5-foot hoses to connect your home's hot and cold water valves to the washer, helping maintain a secure connection and consistent filling.
- Connects hot and cold water faucets to the washer's inlet valves
- Replace if hoses are leaking, cracked, bulging, or kinked
- Can help address slow filling caused by restricted or kinked hoses
- Useful when installing or relocating a washer
What's included: Two 5-ft water inlet hoses. Install notes:
- Unplug the washer and shut off both water supply valves before starting
- Place a towel or pan to catch residual water; disconnect old hoses from faucet and washer
- Match hot to hot and cold to cold; hand-start threads to avoid cross-threading, then tighten firmly without overtightening
- Restore water and power; run a fill test and check all connections for leaks
Do-It-Yourself Stories from Customers like You
Whirlpool Cabrio displayed lf would not complete a wash cycle. Brandy H. • Colorado Springs , CO • August 25, 2020
Purchased water inlet valve and new hot and cold water hoses. Unscrewed about 5 screws that were holding the top of the washer in place then slide the top forward and up. Released the control top it popped off no screws. Disconnected the wires attached and unscrewed 2 screws holding the valve in place the popped that off. Popped in a new valve and repeated the process in reverse. Boom done! Very simple works like new!
Read more