Alexey for Model Number she43Rl5uc My Bosch SHE43RL5UC dishwasher was running too long, not dissolving the tablet fully, and the dishes were clean. Looked like a heater problem so I replaced the entire heater assembly. That didn't help much. The tablet was now getting dissolved but it still ran too long and looked like it was restarting cycles. Did the diagnostics on it and it showed E1. Since heater assembly is brand new, I figured it must be a control board. Purchased a control board from you guys, popped it in yesterday, restarted, E1 went away at first. Ran a normal cycle. That took four hours instead of 110 min as supposed. Dishes were still a bit dirty and the E1 is now back. Any ideas? This is now becoming a personal mission to beat my dishwasher into submission :). All I can think now is the water intake valve. I added some water before running it this morning and testing it now. Thanks P.S. Interestingly enough, normal cycle yesterday was 110 min. Today when I started, it was about 155 and a half load was longer than normal yesterday. I think it's possessed.
Answer Hello Alexey, This could be an issue with the harness or a problem with the NTC sensor 00165281. Read More... Answered by AppliancePartsPros.com | Friday, August 2, 2019